5 2 ensure the water level in water bath.
Laboratory water bath maintenance.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
How scientists use a bath also matters.
Wipe any debris off of the seal and avoid spilling water into the unit to avoid damage to electrical components.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
Some top tips include the following.
It should be sufficient to pour the heating element.
If you can find the user manual for the water bath you should check to see if there are any special cleaning instructions.
Maintenance for water filled baths it is recommended that the bath is drained cleaned and re filled on a weekly basis to avoid build up of salts and contamination.
5 3 wash the lid properly with purified water.
5 2 remove the lid from the water bath.
Afterwards thoroughly rinse the bath with water to make sure no soap is left behind.
Our microprocessor controlled thermo scientific water baths provide superior temperature uniformity for your specific applications and offer unique features such as a seamless stainless steel interior chamber and epoxy coated exterior which make them resistant to corrosion and chemical damage.
Use only distilled water float the sample so the lids stay dry and keep the bath covered as much as possible.
Cranson adds place your bath away from high traffic doorways and out of direct sunlight.
Avoid the use of chlorine containing cleaning supplies such as bleach and abrasive scrubbers because they will damage the bath and cause it to rust.
5 1 ensure that the platform is dry.
Since almost all laboratory water bath has a digital interface to allow users to set a required temperature usually an indicator light turns on to indicate that the water bath is working.
5 2 connect the power supply.
You should never use bleach in a misguided attempt to sterilize a water bath because it will corrode the stainless steel interior.
Regularly adding fresh water will replenish the oxygen which helps maintain the protective chromium oxide layer on the stainless steel.
5 1 switch off the mains.
Once the correct temperature is reached the laboratory water bath turns on and off to maintain a constant temperature.
When the pan is removed for cleaning ensure the unit is unplugged.
Clean the empty bath with soapy water and a cloth.
5 4 switch on the main power supply and instrument mains.
Use only a damp cloth with mild detergents avoiding any corrosive cleaning agents.
It is important to refill the bath with the right kind of water.
This is especially important if the water is stationary or has been boiled.
